2014 Turner DHR (medium) Legendary DownHill Racer. Fitted with a 2015 Cane Creek double barrel air shock, providing circa 8.4 of rear wheel travel! But the clever dw-link setup means this a very pedal-friendly ride to get back up the hill :- I was using it with a pair of Fox 40′s and the combination was the most capable suspension I have ridden. I always try to build my bikes as light as possible, so I was quite happy with the weight savings of the cane creek, but if you want to go back to a coil shock, I can supply the frame without a shock and at a discounted price (message me to discuss). I will leave the hope headset and sram gxp bottom bracket fitted. Rear axle is a 12x150mm bolt-through. Turner frames have always been of the highest quality, but with the last iteration of the DHR they really produced an engineering masterpiece. The cnc machining on the central section is exceptional. I seem to remember Dave Turner said the cnc bill during production was quite excessive! Probably why the frames were over 2k. Condition is generally good. The bearings were repacked with grease and then I only did a few rides before it was put into storage. Negatives – a little chain wear and cable rub, some marks on the downtube near the bottom bracket, two small dents from the previous owner, see pictures for ref, but they do not affect performance of the frame. I was running the bike with mastic tape over any points of abrasion, but I have removed it all so you can see any marks pre-existing on the frame.
